热门搜索:

深圳市天吉芯技术开发有限公司主营产品:无线音频方案、Atmel触摸屏方案、DAC解码器、充气泵MCU方案开发、5.8G无线音频方案,2.4G无线音频方案,Microchip ATMEL MaxTouch 电容触摸屏解决方案,功放芯片 ,耳放芯片,运放芯片,DC-DC电源芯片,AKM音频ADC DAC CODEC DSP,typec转接头、蓝牙音响、拉杆音箱、

    stm32寄存器编程与库函数编程

    更新时间:2024-05-04   浏览数:67
    所属行业:电子 电子产品设计
    发货地址:广东省深圳市  
    产品数量:20000.00个
    价格:面议
    型号ATTINY88-AU 品质原装 库存现货 包装真空 仓库深圳仓库
    ATtiny88 Automotive 8-bit AVR Microcontroller with 8K Bytes In-System Programmable Flash DATASHEET Features High performance, low power AVR 8-Bit microcontroller Advanced RISC architecture 123 powerful instructions most single clock cycle e...
    ThePC7 and PC[5:0] output buffers have symmetrical drive characteristics with both sink and sourcecapability. As inputs, Port C pins that are externally pulled low will source current if the pull-upresistors are activated. The Port C pins are tri-stated when a reset condition becomes active,even if the clock is not running.1.1.7PC6/RESETIf the RSTDISBL Fuse is programmed,
    stm32寄存器编程与库函数编程
    As inputs, Port A pins that are externally pulled low will source current if the pull-up resistorsare activated. The Port A pins are tri-stated when a reset condition becomes active, even if theclock is not running.This port is available in 32-lead TQFP, 32-pad QFN and 32-ball UFBGA packages, only.1.1.5Port B (PB7:0)Port B is an 8-bit bi-directional I/O port with internal pull-up resistors (selected for each bit). ThePort B output buffers have symmetrical drive characteristics with both sink and source capability.As inputs, Port B pins that are externally pulled low will source current if the pull-up resistors areactivated.
    stm32寄存器编程与库函数编程
    The Port B pins are tri-stated when a reset condition becomes active, even if the clockis not running.Depending on the clock selection fuse settings, PB6 can be used as input to the internal clockoperating circuit.The various special features of Port B are elaborated in “Alternate Functions of Port B” on page69.1.1.6Port C (PC7, PC5:0)Port C is a 8-bit bi-directional I/O port with internal pull-up resistors (selected for each bit).
    stm32寄存器编程与库函数编程
    1.1Pin Descriptions1.1.1VCCDigital supply voltage.1.1.2AVCCAVCC is the supply voltage pin for the A/D converter and a selection of I/O pins. This pin shouldbe externally connected to VCC even if the ADC is not used. If the ADC is used, it is recom-mended this pin is connected to VCC through a low-pass filter, as described in “Analog NoiseCanceling Techniques” on page 172.The following pins receive their supply voltage from AVCC: PC7, PC[5:0] and (in 32-lead pack-ages) PA[1:0].
    The ATtiny48/88 is a low-power CMOS 8-bit microcontroller based on the AVR enhanced RISCarchitecture. By executing powerful instructions in a single clock cycle, the ATtiny48/88 achievesthroughputs approaching 1 MIPS per MHz allowing the system designer to optimize power con-sumption versus processing speed.
    http://qq1299968664.b2b168.com